Page 1 of 1
Point Select tool Issue
Posted: Sun Nov 24, 2019 10:15 pm
by Yosemite Sam
Hey guys, I've finally switched over to Moho 13 permanently. I noticed the points select tool default has changed. I now have to hold control to get the lasso function. Does anyone know how to reverse this? I use the lasso about 99% of the time, so this is quite frustrating. I looked through preferences, but couldn't find a solution there. Thanks!
Re: Point Select tool Issue
Posted: Mon Nov 25, 2019 3:30 am
by synthsin75
There's a lasso checkbox in the tool options, and control temporarily toggles to the opposite of that setting. The new install is likely set to the default.
Re: Point Select tool Issue
Posted: Mon Nov 25, 2019 3:39 am
by Yosemite Sam
synthsin75 wrote: ↑Mon Nov 25, 2019 3:30 am
There's a lasso checkbox in the tool options, and control temporarily toggles to the opposite of that setting. The new install is likely set to the default.
how did I miss that... thanks again Wes.
Re: Point Select tool Issue
Posted: Mon Nov 25, 2019 4:45 am
by synthsin75
Glad I could help.
