Page 1 of 1

patch layer problem ,please show layer number and use

Posted: Wed Feb 18, 2015 7:17 pm
by halmaki
I'm in trouble about a preview's being not right.
Image
---------------------------------
The transparent areas where I don't intend to combine the shape this when making it a patch layer, are made.
Image
Image

--------------------------
I'm also in trouble about the following thing.

Image

So I request the number of the layer by which it seems to establish it inside the software as shown in the lower figure to be indicated.
Image

I'd like to make sure that you can designate a tab of patch by a number as follows on the setting screen of a layer and refer to it.
Image

Masking is also to designate the number of the optional layer, and I'd like to hang a clipping by the clarity of the layer designated as only the layer.
Image

-----------------------
Now,Patch layer is copied Fill only.but I need "outline only"and "both fill and line".please select at layer settiong.
also,please mesh-instance layer without script.(refer layer number...)
I'm sorry in unskillful English, but please take care.