Can't remove blur

Have you come up with a good Moho trick? Need help solving an animation problem? Come on in.

Moderators: Víctor Paredes, Belgarath, slowtiger

Post Reply
User avatar
nikkol
Posts: 26
Joined: Mon Jan 29, 2018 10:36 am
Location: Sweden

Can't remove blur

Post by nikkol »

Hello!

Got this problem.

I have made a monster crawling in Moho 12 Pro which I'm going to put in a non-animated scene via Motion 5.
Because the monster is going to be barely visible in the shadows of a wood I blurred the "Monster layer" before exporting.
This didn't ended up good-looking when added to the scene so I thought it would be better to blur it afterwards in motion instead.
Went back to Moho to take away the blur. But I don't understand how?
Now it starts on frame 1 with 0.0005 blur and ends up on frame 360 with blur 22.4996. When I try to change it it's just switch to 22.4996 again.
When I have that layer selected I have a keyframe on frame 1, and one on frame 360. Tried to change both to 0.
Why this behaviour, what have I done wrong?
Best regards, Niklas
mrc
Posts: 116
Joined: Wed Feb 14, 2018 10:36 am
Location: Berlin, Germany
Contact:

Re: Can't remove blur

Post by mrc »

Why don't you just delete both keyframes and set the blur for the layer on frame 0?

Marc
You don't agree with the post above? Click here.
www.tricklabor.com/en
User avatar
nikkol
Posts: 26
Joined: Mon Jan 29, 2018 10:36 am
Location: Sweden

Re: Can't remove blur

Post by nikkol »

Haha, of course.
Spent a lot of time last night thinking and missing the obvious.
Thanks!
User avatar
nikkol
Posts: 26
Joined: Mon Jan 29, 2018 10:36 am
Location: Sweden

Re: Can't remove blur

Post by nikkol »

The clip is not quite finished yet but here's how I added the "monster" I created in Moho. It's barely visible near the end.



Filmed with a Canon Eos 550D, edited in Final Cut and Motion.
Post Reply