Change layer types
Posted: Sat Aug 06, 2005 5:39 pm
I think it would be useful if you could change the layer type from one to another.
I realise it wouldn't be possible to change between a lot of them but where it could be done it should be possible, I think of the folder type layers, group, switch and bone.
Where I miss it right now is when positioning parts in a switch layer, it's much easier to align the parts when you see them all at once, meaning I have to first put them in a group layer and align them and then move them to a switch layer.
I realise it wouldn't be possible to change between a lot of them but where it could be done it should be possible, I think of the folder type layers, group, switch and bone.
Where I miss it right now is when positioning parts in a switch layer, it's much easier to align the parts when you see them all at once, meaning I have to first put them in a group layer and align them and then move them to a switch layer.