Hello!
Got this problem.
I have made a monster crawling in Moho 12 Pro which I'm going to put in a non-animated scene via Motion 5.
Because the monster is going to be barely visible in the shadows of a wood I blurred the "Monster layer" before exporting.
This didn't ended up good-looking when added to the scene so I thought it would be better to blur it afterwards in motion instead.
Went back to Moho to take away the blur. But I don't understand how?
Now it starts on frame 1 with 0.0005 blur and ends up on frame 360 with blur 22.4996. When I try to change it it's just switch to 22.4996 again.
When I have that layer selected I have a keyframe on frame 1, and one on frame 360. Tried to change both to 0.
Why this behaviour, what have I done wrong?
Best regards, Niklas
Can't remove blur
Moderators: Víctor Paredes, Belgarath, slowtiger
Re: Can't remove blur
Why don't you just delete both keyframes and set the blur for the layer on frame 0?
Marc
Marc
Re: Can't remove blur
Haha, of course.
Spent a lot of time last night thinking and missing the obvious.
Thanks!
Spent a lot of time last night thinking and missing the obvious.
Thanks!
Re: Can't remove blur
The clip is not quite finished yet but here's how I added the "monster" I created in Moho. It's barely visible near the end.
Filmed with a Canon Eos 550D, edited in Final Cut and Motion.
Filmed with a Canon Eos 550D, edited in Final Cut and Motion.