Moho Forum

I just upgraded from ASP 6 to 7, and I can hardly wait to get to know 7 better. But my drawings that I did in 6 are visible only when I highlight their group or bone layer parents- highlighted on their own, I only see wire-frames. They don't show up at all when I highlight the switch layers.

I inspected all the "visibility" boxes in all the layers, and they all say I should be seeing something. Did something get lost in the translation from 6 to 7?

(Sigh) Well, may as well answer my own post. I found that in ASP 7, when editing a drawing within a switch layer, the layer needs to be at the top in the frame to see what I'm doing. Whatever....

Sorry, I didn't see this thread before. But you are right, AS7 has a problem with switch layers. It only shows the content when your selected is the switched on.

selgin wrote:Sorry, I didn't see this thread before. But you are right, AS7 has a problem with switch layers. It only shows the content when your selected is the switched on.

That is just poor.